Page 917375-6-0705
REAR VENT CONVERSIONNote: Discard insulation
&retainer when using
verticalventing off
VERTICAL VENTING
HORIZONTAL VENTING
FLUEINSULATION
INSULATION
RETAINER
INLETVENT COLLAR
INLETVENT COLLAR
FLUEOUTLET
COLLAR
FLUECOVER PLATE
(Seenote above)
INLETVENT
COVERPLATE
FLUECOVER PLATE
INLETVENT
COVERPLATE
Note: It is recommended that the
fluecover plate tab be pulled
outwardprior to removal.
Thiswill ensure that the plate
isnot accidentally dropped
insidethe rear air chamber.
Note:Discard insulation
&retainer when venting off
topof fireplace.
Converting flue take-off to rear venting
When switching out the flue and inlet vent collars to run
horizontally off the rear vent, the following steps must be taken.
1. Remove the inlet vent collar (8 screws) and flue collar (4
screws) from the top of the fireplace, and set to the side.
2. Remove the inlet cover plate and flue cover plate located on
the back of the fireplace. These will be used to close the top
flue and inlet openings.
3. Insert the insulation retainer bracket and insulation into the
top flue pipe before reinstalling the flue cover plate over the
top flue with 4 screws.
4. Reinstall the inlet cover plate over the top inlet opening with
4 screws. See illustration above..
5. Install the flue collar assembly to the rear flue with 4 screws.
6. Install the inlet vent collar to the rear of the fireplace with 8
screws.
7. This completes the conversion for a rear vent application.
Note: for top vented installations, the insulation and retainer
are to be removed from the flue pipe and discarded.
VENT SYSTEMS