Empire Comfort Systems VFDR24LB, VFDR30LB, VFDR18LB VFDR18,24 LOG Placement 5 LOG SET

Models: VFDR18LB VFDR24LB VFDR30LB

1 24
Download 24 pages 63.14 Kb
Page 12
Image 12

VFDR(18,24) LOG PLACEMENT (5 LOG SET)

Before you begin: if you are installing logs onto the VFDR18 or VFDR24 models, this burner assembly is supplied with a set of five ceramic fiber logs. Do not handle these logs with your bare hands! Always wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with soap and water to remove any traces of fibers.

The positioning of the logs is critical to the safe and clean operation of this burner assembly. Sooting and other problems may result if the logs are not properly and firmly positioned on the burner assembly. Refer to Figure 12 and Figure 13 and corresponding WARNING: when completing following log placement instruc- tions.

1.Place front logs (#1 and #2) between front grate flange and main burner. Align notches on front logs with locator tabs in base.

2.Place middle log (#3) between front and rear loop of burner. Note: Do not place log on top of pilot assembly.

3.Place rear log (#4) on rear log shelf. Bottom flange of log must be placed between the log shelf and burner tube.

4.Place front twig (#5) onto (#1) log and flat area on (#3) log. The bottom of the front twig is to be placed behind the grate tang that is second from the left.

EMBER MATERIAL PLACEMENT ON BURNER

5.After all logs are positioned properly, apply Rockwool ember material to the front burner port area. To apply, carefully separate the ember material into small amounts no larger than "dime size" pieces. Fluffed up pieces one layer thick on top of the burner generally works best, and will provide the best ember glow. Do not place ember material more than one layer thick. No more than (2) two small packets of ember material (part no. 15998) evenly placed on the burner, is recommended on VFDR18 and VFDR24 models. Using additional ember material will decrease the amount of ember glow effect. Extra ember material should be saved for future ember applications as necessary. See Figure 13.

4

5

3

2

1

Figure 12

WARNING: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.

Attention: Do not use Figure 12 or Figure 13 to order logs. Refer to parts list on page 20 and parts view on page 21 to order logs and/or ember material for your appropriate model.

EMBER MATERIAL PLACEMENT (SHADED AREA ONLY)

Figure 13

Page 12

21565-3-0906

Page 12
Image 12
Empire Comfort Systems VFDR24LB, VFDR30LB, VFDR18LB VFDR18,24 LOG Placement 5 LOG SET, Ember Material Placement on Burner