VFDR(18,24,30)LB LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING 
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance
•Do not touch any electrical switch; Do not use any phone in your building
•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it, call a qualified service tech- nician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1.STOP! Read the safety information above on this label.
2.Set REMOTE/OFF/ON switch to "OFF".
3. Turn off all electric power to the appliance (if applicable).
4. Open bottom louver assembly (if applicable).
5. Push in gas control knob slightly |
| GAS CONTROL KNOB | ||
and turn clockwise | to | SHOWN IN "OFF" POSITION. | ||
|
| |||
"OFF". |
|
| REMOTE | |
NOTE: Knob cannot be turned from "PILOT" | ||||
OFF | ||||
to "OFF" unless knob is pushed in slightly. | ON | |||
Do not force.
8. Turn gas control knob counterclockwise |
to "PILOT". |
9. Push in control knob all the way and hold in. Repeatedly push |
the Piezo Ignitor Button until the pilot is lit. Continue to hold |
the control knob in for about one (1) minute after the pilot is |
lit. Release knob, and it will pop back up. Pilot should remain |
lit. If it goes out, repeat steps 5 through 9. |
• If knob does not pop up when released, STOP and IM- |
MEDIATELY call a qualified service technician or gas |
supplier. |
• If the pilot will not stay lit after several tries, turn the gas |
control knob to "OFF" and call your service technician |
or gas supplier. |
6.Wait ten (10) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow "B" in the safety information above. If you do not smell gas, go to the next step.
PILOT
THERMOPILE
ELECTRODE
THERMOCOUPLE (LPG)
THERMOCOUPLE (NATURAL)
10. | Turn gas control knob counterclockwise | to "ON". |
11. Close bottom louver assembly (if applicable). |
| |
12. | Turn on all electric power to the appliance (if applicable). | |
13. | Set REMOTE/OFF/ON switch to desired setting. |
|
7.Find pilot - Follow metal tube from
gas control. The pilot is located next to the burner, near the right side.
TO TURN OFF GAS TO APPLIANCE
1.Set REMOTE/OFF/ON switch to OFF.
2.Turn off all electric power to the appliance if service is to be performed (if applicable).
3.Open bottom louver assembly (if applicable).
4.Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
5.Close bottom louver assembly (if applicable).
Page 16 |
