General Information

This is an unvented gas-ﬁred heater. It uses air (oxygen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided.

Keep room area clear and free from combustible materials, gasoline and other ﬂammable vapors and liquids.

Unvented gas heaters are a supplemental zone heater. They are not intended to be a primary heating appliance. Water vapor produced by an unvented heater can create moisture problems in a home when operated for extended periods of time.

During manufacturing, fabricating and shipping, various components of this appliance are treated with certain oils, ﬁlms or bonding agents. These chemicals are not harmful but may produce annoying smoke and smells as they are burned off during the initial operation of the appliance; possibly causing headaches or eye or lung irritation. This is a normal and temporary occurrence.

The initial break-in operation should last 2-3 hours with the burner at the highest setting. Provide maximum ventilation by opening windows or doors to allow odors to dissipate. Any odors remaining after this initial break-in period will be slight and will disappear with continued use.

This appliance must not be used with glass doors in the closed position. This can lead to pilot outages and severe sooting outside the ﬁreplace.

Do not use this room heater if any part has been under water. Immediately call a qualiﬁed service technician to inspect the room heater and replace any part of the control system and any gas control which has been under water.

WARNING: This appliance is equipped for (natural or propane) gas. Field conversion is not permitted.

Before you get started

Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have all parts in good condition.

Make sure you have received all parts:

Check your packing list to verify that all listed parts have been received. You should have the following:

•Gas log grate/burner assembly.

•Two (2) masonry anchoring screws and two (2) 10 x 1/2" black sheet metal anchoring screws.

•Ceramic Log Set - (5 Piece on VFDR(18,24), (7 piece on VFDR30)

•Plastic bag containing glowing embers (rock wool) for burner coverage.

This millivolt controlled heater may be operated with optional devices for REMOTE/OFF/ON functions.

a.Wall switch or thermostat with wire.

b.Hand held remote control with ON/OFF switch or thermostat.

Handle the gas log burner assembly by the grate and legs only. Do not pick the unit up by the burner.

Gloves are recommended when handling logs to prevent skin irritation. Logs are fragile - Handle with care.

Qualiﬁed Installing Agency

Installation and replacement of gas piping, gas utilization equip- ment or accessories and repair and servicing of equipment shall be performed only by a qualiﬁed agency. The term "qualiﬁed agency" means any individual, ﬁrm, corporation, or company that either in person or through a representative is engaged in and is responsible for (a) the installation, testing, or replacement of gas piping or (b) the connection, installation, testing, repair, or servicing of equipment; that is experienced in such work; that is familiar with all precau- tions required, and that has complied with all the requirements of the authority having jurisdiction.

State of Massachusetts: The installation must be made by a licensed plumber or gas fitter in the Commonwealth of Massachusetts.

Sellers of unvented propane or natural gas-ﬁred supplemental room heaters shall provide to each purchaser a copy of 527 CMR-30 upon sale of the unit.

In the State of Massachusetts, unvented propane and natural gas-ﬁred space heaters shall be prohibited in bedrooms and bathrooms.

The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1.*

*Available from the American National Standards Institute, Inc. 11 West 42nd St., New York, N.Y. 10018.

High Altitude

When installing this unit at an elevation above 2,000 feet (in the United States), it may be necessary to decrease the input rating by changing the existing burner oriﬁce to a smaller size. Generally, input should be reduced 4 percent for each 1,000 feet above sea level. However, if the heating value of the gas has been reduced, this general rule may not apply. Check with local gas utility for proper oriﬁce size identiﬁcation.

WATER VAPOR: A BY-PRODUCT OF UNVENTED ROOM HEATERS

Water vapor is a by-product of gas combustion. An unvented room heater produces approximately one (1) ounce (30ml) of water for every 1,000 BTU's (.3KW's) of gas input per hour.

Unvented room heaters must be used as supplemental heat (a room) rather than a primary heat source (an entire house). In most supplemental heat applications, the water vapor does not create a problem. In most applications, the water vapor enhances the low humidity atmosphere experienced during cold weather.

The following steps will help insure that water vapor does not become a problem.

1.Be sure the heater is sized properly for the application, including ample combustion air and circulation air.

2.If high humidity is experienced, a dehumidiﬁer may be used to help lower the water vapor content of the air.

3.Do not use an unvented room heater as the primary heat source (an entire house).

Page 6

21565-3-0906

VFDR18LB, VFDR24LB, VFDR30LB specifications

Empire Comfort Systems specializes in high-quality heating solutions, and their VFDR series, which includes the VFDR30LB, VFDR24LB, and VFDR18LB models, showcases the company’s commitment to innovation and efficiency. These vent-free gas log fireplaces are designed to provide warmth and ambiance, making them perfect for any living space.

One of the standout features of the VFDR series is the vent-free design, which allows for easy installation. These fireplaces do not require a chimney or flue, providing flexibility in placement without the need for extensive renovations. This vent-free feature enables the fireplaces to operate efficiently while releasing warmth directly into the room, making them an excellent choice for standing out in compact spaces.

The VFDR models are equipped with advanced technology, including a patented dual burner system. This unique burner design allows for a more realistic flame appearance while maximizing heat output. The result is a mesmerizing fire that enhances the ambiance of any setting. Additionally, the variable flame height control lets users adjust the intensity of the fire, providing customizability according to individual preferences.

When it comes to safety, Empire Comfort Systems has integrated several features in the VFDR series. The fireplaces include an Oxygen Depletion Sensor (ODS), which automatically turns off the burner if the oxygen levels in the room drop too low, ensuring peace of mind while using the appliance. Furthermore, the appliances are built with a safety pilot light, reinforcing their reliability and user safety.

Each model in the VFDR series comes with different heat output capabilities. The VFDR30LB provides up to 30,000 BTUs, making it suitable for larger spaces, while the VFDR24LB and VFDR18LB cater to medium and smaller areas with outputs of 24,000 and 18,000 BTUs, respectively. This versatility allows homeowners to select the perfect model based on their heating needs.

The VFDR series is also visually appealing, featuring a realistic log set and a stylish finish that complements a variety of interior designs. With a wide range of decorative options available, consumers can customize their fireplace to enhance their home’s aesthetic.

In summary, the Empire Comfort Systems VFDR30LB, VFDR24LB, and VFDR18LB models are an exceptional choice for anyone seeking a reliable, efficient, and stylish heating solution. Their vent-free design, innovative burner system, safety features, and aesthetic appeal make them standouts in the market. Whether for a cozy living room or an inviting den, these fireplaces provide the perfect combination of functionality and warmth.

Empire Comfort Systems VFDR24LB General Information, Before you get started, High Altitude

Models: VFDR18LB VFDR24LB VFDR30LB