Emulex 4 Gb FC Host Bus manual Removing the Bracket Screws

The single channel SG-XPCIE1FC-EM4 will have one IEEE address, the dual channel SG-XPCIE2FC-EM4 will have two IEEE addresses. The IEEE address is used when configuring your system. The serial number is used when communicating with Sun. All numbers are clearly marked on the board. Record these numbers before installation.

2.Shut down, power off, and unplug the computer.

3.Remove the computer case.

4.Remove the blank panel from an empty PCI Express slot.

5.(Optional) Perform the following steps to replace the PCI bracket.

Note – The HBA comes with a low-profile PCI bracket installed. This bracket is approximately 3.11 in. (7.9 cm) long. A standard mounting bracket, which is approximately 4.75 in. (12.6 cm), is provided with each X-option order.

a. Remove the mounting bracket screws from the HBA (see FIGURE 2).

FIGURE 2 Removing the Bracket Screws

b. Remove the bracket and store it for future use.

c. Align the new mounting bracket tabs with the holes in the HBA.

Note – Be careful not to push the bracket past the transceiver housing’s grounding tabs. Ensure that the LEDs are properly aligned with the holes in the bracket.

d. Replace the screws that attach the HBA to the bracket.

6.Insert the HBA into the empty PCI Express 4-lane slot. Press firmly until the adapter is seated.

4 Sun StorageTek PCI Express Enterprise 4 Gb FC HBA Emulex Installation Guide • December 2005