Hardware Installation | EnGenius Technologies EAP350 guide

13

2.4Hardware Installation

1)Ensure that the computer in use has an Ethernet Card (RJ-45 Ethernet Port). For more information, verify with our computer user manual.

2)Connect one end of the Category 5 Ethernet cable into RJ-45 port of the EAP350 and the other end to the RJ-45 port on the computer that will use the EAP350. Ensure that the cable is securely connected to both the EAP350 and the Computer.

3)Connect the Power Adaptor DC Inlet to the DC-IN port of the EAP350 and the Power Adaptor to the electrical out. Once both connections are secure, verify the following:

a)Ensure that the Power light is on (it will be blue).

b)Ensure that the Wireless light is on (it will be blue).

c)Ensure that the LAN (Computer/EAP350 Connection) light is on (it will be blue).

d)Once all three lights are on, proceed to setting up the computer.

This diagram depicts the hardware configuration.

Image 14

EnGenius Technologies EAP350 manual Hardware Installation

Contents

EAP350 Table of Contents Error! Bookmark not defined Appendix a FCC Interference Statement Building a Wireless NetworkManagement Date Revision HistoryVersion Features and Benefits Introduction Package Contents System Requirements Applications Small Office and Home Office Soho Networks Wireless Extensions to Ethernet networksWired LAN backup Training/Educational facilities Considerations for Wireless Installation Before you Begin Computer Settings Windows XP/Windows Page Page Select Network in the Internet & Network section Configure IPv4, select ManuallyApple Mac X OS Hardware Installation Front Panel Rear Panel Default Settings Configuring Your Access PointDefault Settings Web Configuration If successful, you will see the EAP350 User Menu Status Save/Reload Main Page Wireless Client List System Log Refresh Update the log Clear Clear the log System Log Operation Mode System System Properties Device Name Operation ModeAccept / Cancel Country/Region IP Settings This page allows you to modify the devices IP settings Spanning Tree Spanning Tree Status Spanning Tree SettingBridge Forward Delay Bridge Hello TimePage Wireless Wireless Network Extension Channel Wireless Network Wireless ModeChannel HT Mode Channel / Frequency Specify the Ssid for current profile Ssid ProfileSsid Profile Specify the Vlan tag for the current profile Wireless Security WEP Encryption Default Key Encryption Key # WPA-PSK WPA Pre-Shared Key Encryption WPA Pre-Shared Key Encryption WPA Encryption Wireless MAC Filter Wireless Filter Access Point / WDS AP mode Wireless Advanced Wireless Traffic Wireless Advanced Data RateTransmit Power RTS/CTS Threshold WPS Wi-Fi Protected Setup WPS Current Status Wi-Fi Protected Setup WPSAuthentication Mode Self Pin Code WDS Link Settings WDS Link Settings MAC Address Administration Management Management Vlan Management Vlan Snmp SnmpPage Backup/Restore Firmware Upgrade To perform the Firmware Upgrade Automatically Get Date Time SettingTime Manually Set Date and Time Time Log Diagnosis LED Control Logout Reset Building a Wireless Network Access Point Mode Access Point Mode with WDS Function WDS AP mode WDS Bridge Mode Federal Communication Commission Interference Statement FCC Radiation Exposure Statement