England's Stove Works PELLET STOVES operation manual Call Technical Support at 800, Control Board

Control Board

The Control Board (Part #PU-CB04) is a digital read-out board. This board offers a wide variety of settings to operate the unit. This part can be removed from the unit by loosening the two outside screws and pulling the board back to the inside of the stove. The rear access panel should be removed prior to removing the control board. A 6-amp “quick-blow” fuse is used on this Control Board.

NOTE: The bottom three control buttons are preset at the factory and should not require any changes. See “Operating Instructions” and “Daily Operation” section of the manual for instructions on other Control Board settings.

	Recommended Heat Ranges:
Low Burn:	Heat Range setting:	1		Room Air Blower setting:	1
Medium Low:	Heat Range setting: 2		– 3	Room Air Blower setting: *
Medium High:	Heat Range setting:	5	– 8	Room Air Blower setting: *
High Burn:	Heat Range setting:	9		Room Air Blower setting:	9

* NOTE: Blower Speed will automatically be adjusted to the desired Heat Range that you select.

CAUTION:

NOTE: The bottom

3buttons are pre-set at the factory and do not need adjustment.

Call Service at

(800) 245-6489 if you have questions or problems.

Illustration 3

Control Board

Diagram

Caution

Should you see any evidence of smoke in the hopper (smoke back), immediately close and latch the hopper lid and door to the unit. Open the nearest windows and door to the outside, then press the OFF button and let the unit cool for at least 3 hours. Do not open the door or hopper lid. This is a maintenance problem that needs to be addressed.

Call Technical Support at (800) 245-6489.

17