Managing Ethernet MicroLAN Switches
5-20 Trap Selection
Accessing the Trap Selection Windows
To open the repeater-level Trap Selection window from the Chassis View:
1. Click on Repeater on the Chassis View menu bar. Select the appropriate
repeater to reveal the Repeater menu.
2. Click on Trap Selection. The Repeater Trap Selection window, Figure5-6,
opens.
Figure5-10. Repeater Trap Selection Window
To access the board-level Trap Selection window:
1. Click on the appropriate Module Index to display the Module menu.
2. Select the appropriate repeater channel (A - H) to reveal the board-level
Repeater menu.
3. Click on Trap Selection. The Board Trap Selection window opens.
To access the port-level Trap Selection window:
1. Click on the appropriate Port index to display the Port m enu.
2. Click on Trap Selection. The Port Trap Selection window opens.
NOTE
In order for your device to issue any traps – and in order for your management
workstation to receive those traps – your Ethernet MicroLAN Switch’s trap table must
have been properly configured via Local Management; see the Ethernet MicroLAN Switch
hardware manual or Local Management documentation for more information.
At the repeater or board level, a three-state
check box indicates the state of settings for
all ports that are on the repeated network.
The check box will be:
Grayed – If individual port-level settings
have mixed enabled and disabled states for a
given trap.
Checked – If all port trap settings are
enabled for a given trap.
Blank – if all port trap settings are disabled
for a given trap.