Installing the Switch on a Flat Surface
Figure 3-3 Chassis Bottom, Rubber Feet Placement
Á | À |
 |  |
 |  |
1Bottom of chassis as seen when chassis is resting on its back
2Locations to install the rubber feet (four locations)
3Rubber feet with adhesive backing (four)
4.Remove the protective strip from the back of one rubber foot and position it on a marked location and press firmly into place. Repeat this procedure to install the remaining three rubber feet.
5.After installing the rubber feet, return the switch to its upright position.
Note: If a number of switches are being installed in a stack, repeat steps 1 through 4 to install the rubber feet on each switch before continuing with the installation.
6.To install switches on a flat surface, proceed to “Guidelines for Flat Surface Installation” on page 3‐8. For a rackmount installation, proceed to “Rack Mounting the Switch” on page 3‐9.
SecureStack C3 Installation Guide
