![](/images/new-backgrounds/1110352/11035251x1.webp)
About This Guide
This guide provides an overview, installation and troubleshooting instructions, and specifications for the Enterasys® SecureStack C3G124‐24P and C3G124‐48P stackable PoE Gigabit Ethernet switches.
For information about the Command Line Interface (CLI) set of commands used to configure and manage the C3G124‐24P or C3G124‐48P, refer to the Enterasys Networks® SecureStack C3 Configuration Guide.
This preface provides an overview of this guide and the SecureStack C3 manual set, and explains the symbols used throughout this guide.
Note: In this guide, the following terms are used:
• Switch refers to both
•MGBIC
•PoE refers to Power over Ethernet (IEEE 802.3af).
Important Notice
Depending on the firmware version used in the switch, some features described in this document may not be supported. Refer to the Release Notes shipped with the switch to determine which features are supported.
Who Should Use This Guide
This guide is intended for a network administrator responsible for installing and setting up the stackable switches.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes Personal vorgenommen werden.
SecureStack C3 Installation Guide xv