ADVANCED FUNCTIONS
To program, or “record” an activity, follow these steps:
1.To enter Program mode, simultaneously press and hold the Activity Button and the Alphanumeric Key or AVR Power On or Off Button to which the activity will be assigned.
2.Press the Source Selector (or Setup Button) for each device before you enter individual commands. This step counts as one of the 19 commands allowed for each activity.
3.For Power On, press the AVR or Device Power On Button.
4.Press the AVR or Device Power Off Button for Power Off.
5.Press the Activity Button to end the programming process, and the last Source Selector (or the Setup Button) will flash three times.
It isn’t possible to “edit” a command within an activity. To erase the activity:
1.Press and hold the Activity Button and the Alphanumeric Key or AVR Power On or Off Button until the Source Selector or Setup Button lights.
2.Press the Activity Button to erase the activity.
PROCESSOR RESET
If the unit behaves erratically after a power surge, first turn off the Main Power Switch and unplug the AC power cord for at least 3 minutes. Plug the cord back in and turn the receiver on. If this doesn’t help, reset the AVR.
NOTE: A system reset erases all user configurations, including video resolution, speaker and level settings, and tuner presets. After a reset, reenter all of these settings from your notes in the appendix worksheets.
To reset the AVR 460/AVR 360, place it in Standby mode (press the front- panel Standby/On Switch so that the Power Indicator turns amber). Then press and hold the
If the receiver does not function correctly ofter a processor reset, contact an authorized Harman Kardon service center for assistance. Authorized service centers may be located by visiting the Web site at www.harmankardon.com.
ENGLISH
To execute an activity, press the Activity Button, then press the Alphanumeric | NOTE: After performing a system reset, wait at least 1 minute before | |
pressing any Source Selectors. | ||
Key (or the AVR Power On or Off Button) for the Activity. | ||
|
Learning (AVR 460 only) | MEMORY | |
If you have programmed a product’s codes into the remote and find that some | ||
If the AVR 460/AVR 360 is unplugged or experiences a power outage, it will | ||
functions are missing, the AVR 460 remote may “learn” individual codes from | ||
retain user settings for up to four weeks. | ||
the product’s original remote. See page 24 in the Basic Manual. | ||
| ||
Resetting the Remote |
| |
To reset the remote to its factory defaults, simultaneously press and hold |
| |
the TV Source Selector and the “0” Alphanumeric Key. When the TV Button |
| |
relights, enter the code “333”. When the TV Button goes out, and all of the |
| |
Source Selectors flash, the remote control will be reset. |
|
13
