Enterasys Networks D-Series set cos settings

set cos settings
Enterasys D-Series CLI Reference 11-21
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocleartheCoSstatebacktoitsdefaultsettingofdisabled:
D2(su)->clear cos state
set cos settings
UsethiscommandtoconfigureaClassofServiceentryintheCoSsettingstable.
Syntax
set cos settings cos-index priority priority [tos-value tos-value] [irl-reference
irl-reference]
Parameters
Defaults
Ifnooptionalparametersarespecified,nonewillbeapplied.
Mode
Switchcommand,read‐write.
Usage
TheCoSsettingstabletakesindividualclassofservicefeaturesanddisplaysthemasbelongingto
aCoSentry.Essentially,itisusedforCoSfeatureassignment.Eachclassofserviceentryconsists
ofanindex,802.1ppriority,anoptionalToSvalue,andanIRLreference.
•CoSIndex
IndexesareuniqueidentifiersforeachCoSsetting.CoSindexes0through7arecreatedby
defaultandmappeddirectlyto802.1ppriorityforbackwardscompatibility.Theseentries
cannotberemoved,and802.1ppriorityvaluescannotbechanged.WhenCoSisenabled,
indexesareassigned.Upto256CoSindexesorentriescanbeconfigured.
•Priority
802.1pprioritycanbeappliedperCoSindex.ForeachnewCoSindexcreated,theuserhasthe
optiontoassignan802.1ppriorityvalue0to7fortheclassofservice.CoSindexes0through7
mapdirectlyto802.1pprioritiesandcannotbechangedastheyexistforbackward
compatibility.
cos‐index SpecifiesaClassofServiceentry.Validva luesare0to255.
prioritypriority Specifiesan802.1dpriorityvalue.Val idvalue sare0to7,with0beingthe
lowestpriority.SeeUsagesectionbelowformoreinformation.
tos‐valuetos‐value (Optional)SpecifiesaTypeofServicevalue .
irl‐reference
irl‐reference
(Optional)Settheinboundratelimiterassociatedwiththisentry.Valid
valuesare0to99.SeeUsagesectionbelowformoreinformation.