Enviro 50-1220, C-10792 ASH PAN weekly, Not Place Unburned or RAW Pellet Fuel in ASH PAN

Routine Cleaning and Maintenance

If the glass has build up that can not be removed with only the cloth, clean the glass using paper towel and a gas appliance glass cleaner, this may be purchased through most dealers. If a gas appliance glass cleaner is not available, use a damp paper towel dipped in fly ash to clean the glass. After the glass has been cleaned use the dry soft cloth to wiping down the outside and inside of the glass.

ASH PAN (weekly)

This part is located under the door. To remove the ash pan, open the cover from the right hand side, and lift the ash pan up and out. Dump the ashes into a metal container stored away from combustibles. Monitor the ash level every week. Remember that different pellet fuels will have different ash contents. Ash content is a good indication of fuel efficiency and quality. Refer

to “SAFETY WARNINGS AND RECOMMENDATIONS” for

disposal of ashes. Vacuum the inside of the ash pan compartment inside the pedestal including the hole at the top back of the compartment. Replace the ash pan and close pedestal door. DO

NOT PLACE UNBURNED OR RAW PELLET FUEL IN ASH PAN.

AIR INTAKE (semi-annually)

Inspect periodically to be sure that it is not clogged with any foreign materials.

EXHAUST PASSAGES (semi-annually)

Heat exchanger tubes

cleaner handle.

Vacuum the top &

bottom air wash.

Burn pot

clean-out lever.

Empty ash box.

Vacuum inside ash

box compartment.

Figure 6: Bern Open

To prevent build up of fly-ash all the exhaust passages must be cleaned and vacuumed.

Clean behind clean-out covers:

•Open ash box cover.

•Remove ash box.

•Using a 5/16” socket, loosen the six (6) screws in the ash box compartment; four (4) on the back and one (1) on each side (see Figure 7).

•Rotate the back cover counter- clockwise to remove and rotate the side covers to open them.

•Vacuum out all three (3) chambers.

•Close all the clean-out covers and tighten the screws.

Loosen the screw & rotate the cover (left & right sides)

Loosen the four (4) screws, rotate counter-clockwise & remove.

Figure 7: Bern Clean-Out Covers.

11