6. INSTALLATION OF LOG SET and EMBERS
INSTALLING THE GLOWING EMBERS
A bag of ceramic fiber embers is provided for use on the front burner ember tray.
CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the ember material there may be more than required. Use only a single layer. Do not pile embers. The use of other foreign materials on the burners may create dangerous conditions.
If over time, through cleaning and servicing, these embers require replacement, contact your nearest ENVIROGAS dealer for replacement embers.
Gently remove the ember material from the plastic bag. Spreading pieces evenly across the front and rear of the ember tray, place a single layer of embers on top of the front burner.
Carefully avoid any clumping or large
Place cast ember pieces between the door facing and the ember tray. The curved edge is placed into the firebox. Align the mitered corner edges.
DO NOT PLACE EMBERS ON THE REAR BURNER.
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED
INSTALLING THE LOGSET
Carefully remove log from box. Check to ensure there is no damage. It is very important to install this log in its proper position to insure safe, optimum operating
conditions.
1.Open the front door.
2.Place the logset all the way into the back of the firebox resting on the log supports.
3.Close the door and tighten securely.
Upon the first light up, watch for ignition to all burner ports. If a long delay is noted:
a) First, wait for the appliance to cool down
b) Open the front door of the appliance.
c) Check to carefully reposition the embers making sure that burner ports are not plugged solid or blocked.
(See adjusting the venturi section to adjust air for proper flame).
8
