TABLE OF CONTENTS
Safety Precautions | 2 |
Code Approvals | 3 |
Deciding where to locate your stove | 4 |
Planning your installation | 6 |
Installation of Log Sets and Embers | 14 |
Operating Instructions | 15 |
Maintenance and Technical | 16 |
Trouble Shooting | 17 |
Gas Line Connection | 18 |
Electrical | 19 |
Parts and Accessories | 20 |
Fuel Conversion | 21 |
Warranty | 22 |
Parts List | 23 |
Exploded Views | |
Installation Data Sheet | 26 |
Mobile Home Information | 3,13,19,21 |
CODE APPROVALS
•This Direct Vent appliance draws all of its combustion air from outside of the dwelling through specially designed vent pipe.
These appliances have been tested by INTERTEK TESTING SERVICES (WH) and found to comply with the established standards for a DIRECT VENT GAS FIREPLACE in CANADA and the USA as follows:
LISTED GAS FIRED GRAVITY DIRECT VENT WALL FURNACE (EG 28 DV. Nat. & LPG. ) TESTED TO: ANSI
SPECS:
ENVIROGAS EG 28 DIRECT VENT UNITS;
•have all been certified for use with either natural or propane gases. (see control panel and rating label.)
•are not for use with solid fuels.
•must not be connected to a chimney flue serving a separate
•are approved for bedroom or bedsitting room.
(IN CANADA: must be installed with a listed wall thermostat)
(IN USA: see current ANSI Z223.1 for installation instructions.)
•must be installed in accordance with local codes if any. If none exist use current installation code CAN/CGA b149 in Canada or ANSI Z223.1 / NFPA 54 in the USA.
•must be properly connected to an approved venting system.
•Manufactured (mobile) home installation must be in accordance with the Manufactured Home Construction and Safety Standard, UL 307B, Title 24 CFR, Part 3280 and/or The Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A. The unit must be bolted to the floor of the mobile home and must be electrically grounded to the steel chassis.
•are approved for installation on combustible materials.
•are not approved for closet or recessed installations.
ASSEMBLY INSTRUCTIONS
PREPARATION FOR INSTALLATION
•Remove the packaging from the appliance, and check to make sure there is no damage. If damage is found, please report it to both the carrier and your dealer as soon as possible.
•Before beginning, carefully check the glass door and the log set
3
