Maintenance And Service
REPLACING GLASS:
The glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory replacement is required (see PARTS LIST - COMPONENTS). Wear gloves when handling damaged glass door assembly to prevent personal injury. When the glass door assembly is being transported, it must be wrapped in newsprint and tape and/or a strong plastic bag. Do not operate with the glass front removed, cracked or broken. Removal and replacement of the glass from the door must be done by a licensed or qualified service person. The glass must be purchased from an ENVIRO dealer. No substitute materials are allowed.
To Replace: Open door, and remove the glass carefully. Install the new piece of glass with the large bulb in the gasket tape against the unit. Place the joint in the tape in a bottom corner. Close door.
GLASS DOOR REMOVAL:
Turn unit off and wait until the appliance has cooled down. Remove the cast iron top from the unit by lifting straight up. Lift the two door handles located on either side of the door and lift the glass door assembly straight up and out. Carefully open the two doors and remove if necessary.
Ensure the door is properly fastened after cleaning before attempting to
Figure 5. Removing inner glass door.
BURNER REMOVAL:
1.Remove the glass as shown in the MAINTENANCE AND SERVICE - GLASS DOOR REMOVAL.
2.Carefully remove the log set and ember material.
3.Remove the two (2) screws at the back of the fire
box that hold the log support tray in place (see Figure 6). Remove the support tray from the fire box
4.Remove the screw located on the right side of the burner that holds the burner to the chassis inside the fire box. Remove the burner tray from the
firebox. | Figure 6. Removing log support tray. |
|
9
