Envision Peripherals EN9600 manual Installation Instructions Swivel Base, Power Cord, Power Source

INSTALLATION INSTRUCTIONS

SWIVEL BASE

InstallRemove

Figure 1 Installing and Removing the Swivel Base

POWER CORD

Power Source:

1.Make sure that the power cord is the correct type required in your area.

2.This LCD monitor has an External universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required.)

3.Connect the power cord into your LCD monitor￿s power input socket, and then plug the other end into a 3-pin AC power outlet. The power cord may be connected to either a wall power outlet or the power outlet socket your PC, depending on the type of power cord supplied with your LCD monitor.

NOTES

A certified power supply cord has to be used with this equipment. The relevant national installation and/or equipment regulations shall considered. A certified power supply cord not lighter than ordinary polyv chloride flexible cord according to IEC 60227 (designation H05VV-F 3G

22

0.75mm or H05VVH2-F2 3G 0.75mm) shall be used. Alternative a flexible cord be of synthetic rubber according to IEC 60245 (designation H05RR-F 3G 0.75mm 2) shall be used.

5