5. With the help of a second person, hold the con- | 5 |
|
|
sole assembly (E) near the Upright (96). |
|
| |
|
|
| |
Connect the Upright Wire (92) to the console |
| E |
|
wire. See the inset drawing. The connectors |
|
| |
should slide together easily and snap into |
|
|
|
place. If they do not, turn one connector and try |
|
|
|
again. IF YOU DO NOT CONNECT THE CON- |
|
|
|
NECTORS PROPERLY, THE CONSOLE MAY |
|
|
|
BECOME DAMAGED WHEN YOU TURN ON |
|
|
|
THE POWER. |
|
|
|
Then, connect the pulse wires (F). Make sure to |
|
|
|
connect the pulse wires on the right side (not |
|
|
|
shown) also. |
|
|
|
| Console | 92 | F |
| Wire |
|
|
| 92 | 96 |
|
|
|
| |
6. With the help of a second person, hold the | 6 |
|
|
console assembly (E) near the left handrail |
|
| |
|
|
| |
assembly (C). Raise the console assembly |
| E |
|
enough to position the wires (F) so that they will |
|
| |
not get pinched as you set the console assembly |
|
|
|
on the left handrail assembly. Be careful not to |
|
|
|
pinch any wires. |
|
|
|
See the inset drawing. Make sure that the con- |
|
|
|
sole assembly (E) is flush against the handrail |
|
|
|
assemblies (C, D) in the locations shown by the |
|
|
|
arrows. |
|
| F |
Attach the console assembly (E) to the handrail |
|
| C |
assemblies (C, D) with four 5/16" x 3/4" Screws |
|
| |
(1), four 5/16" Flat Washers (6), and four 3/8" |
|
|
|
External Star Washers (4) as shown (only one |
|
|
|
side is shown). Start all four Screws and then |
| 4 |
|
tighten them. |
|
| |
| 6 |
| |
|
|
| |
|
| 1 |
|
|
| D |
|
|
|
| C |
|
| E |
|
| 9 |
|
|
