8.Remove the elastic band holding the Upright Wire Harness (75). Have two people hold the console assem- bly near the Left Upright (73) and the Right Upright (74). Connect the Upright Wire Harness to the console wire.
Make sure to connect the connectors properly (see the inset drawing); the connectors should slide to- gether easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again to connect them. IF THE CON-
NECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
Insert the Upright Wire Harness (75) and the console wire into the Right Upright (74). Next, insert the brackets on the console assembly into the Left Upright (73) and the Right Upright. Be careful not to pinch the wires.
9.While pressing down on the Handrails (99), attach the console assembly to the Uprights (73, 74) with four Upright Bolts (72), four Washers (78), and four Star Washers (71). Start all four Upright Bolts before tight- ening them.
Note: The Left Accessory Tray (63) and the Right Accessory Tray (64) are replaceable. If these parts be- come dislodged from the console assembly, simply press them back in.
10.Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two col- lars, place one on each side of the spring.) Next, insert the pin into the hole in the side of the Handrail (99). Then, tighten the knob back onto the pin.
8 |
|
|
|
| Console |
|
| Assembly |
73 | Bracket | |
| Console Wire | |
| 75 |
|
| 74 |
|
|
| 75 |
9 | 63 |
|
Console |
|
|
Assembly |
| 64 |
|
| |
99 |
|
|
| 72 |
|
| 78 |
|
73 | 71 |
|
78 |
| |
|
| |
| 71 | 74 |
| 99 |
|
10 |
|
|
| Knob |
|
99 |
|
|
|
| Pin |
| Spring |
|
| Collar |
|
9
