5.Attach the Catch (5) to the left side of the Frame (48) with two 3/4” Screws (4).
With the help of a second person, raise the Frame (48) to a vertical position. Be careful not to raise the Frame past the vertical position. Have the other person hold the Frame until step 7 is completed.
5
4 5 48
6.Hold the cylinder end of the Shock (88) near the bracket in the center of the Belly Pan (50).
See the two small inset drawings. Using your fingernail or the end of a screwdriver, press on the end of the Shock Pin (102) to loosen it from the Shock (88). Next, rotate the Shock Pin and pull it out of the Shock. Be careful to avoid losing the Shock Pin.
Orient the Shock (88) so it is in the position shown. Press the end of the Shock onto the ball on the bracket.
See drawing 6a. Insert the Shock Pin (102) into the two indicated small holes in the end of the Shock (88). Then, rotate the Shock Pin until it clips onto the Shock. Note:
Extra Shock Pins are included.
7.Remove the Shock Pin (102) from the lower end of the Shock (88).
Next, press the lower end of the Shock (88) onto the ball on the bracket on the Base (83). If necessary, pivot the Frame (48) slighty and rotate the Shock to align the end of the Shock with the ball on the bracket.
See drawing 7a. Insert the end of the Shock Pin (102) into two of the small holes in the end of the Shock (88). Then, rotate the Shock Pin until it clips onto the Shock.
With the help of a second person, lower the Frame (48) to the floor.
6 | Cylinder | 102 |
| ||
| 50 |
|
| 88 |
|
102 | Bracket | 102 |
6a
88
102
Bracket
| Hole |
| Hole |
7 | 48 |
| 88 |
| 83 |
| 102 |
| Bracket |
7a | 88 |
| |
| 102 |
| Bracket |
8
