Epic Fitness GZFW20611 manual Maintenance, Daily, Weekly

MAINTENANCE

For safe and trouble-free operation of your EPIC STRENGTH™ strength bench, it is important to perform rou- tine preventative maintenance on a regular basis. Make sure that all parts are properly tightened each time the strength bench is used. Replace any worn parts immediately. The strength bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.

Note: Instruct all personnel to perform equipment inspection and maintenance requirements. Personnel must record and report any accident. Contact FreeMotion Fitness Customer Service at 1-800-201-2109 with any questions or concerns.

Use only original EPIC STRENGTH parts for repair or replacement to maintain your bench’s warranty.

FreeMotion Fitness recommends the following procedures:

SCHEDULED MAINTENANCE

DAILY

1.Upholstery—General cleaning:

•Wipe using a soft cloth dampened with a light solution of household dish detergent and warm water.

•If necessary, use a soft bristle brush with the cleaning solution.

•Always remove the cleaning solution using a cloth dampened with clean water. Rinse often.

2.Upholstery—Difficult stains:

•Spray the stain with a non-abrasive household cleaner such as FORMULA 409® cleaner, SIMPLE GREEN®, or a similar product.

•Rub the area gently and let it sit for a few min- utes.

•Rinse thoroughly using a clean, water-damp- ened cloth.

•Repeat if necessary using a soft bristle brush.

Optional method for difficult stains:

•Rub the area gently using a soft cloth damp- ened with rubbing alcohol.

•Rinse thoroughly using a water-dampened cloth to remove alcohol residue.

CAUTION: When using any cleaning product, try it first in an inconspicuous place to ensure there is no damage to the material. Follow directions and adhere to safety precautions of each manu- facturer of cleaning agent used. FreeMotion Fitness and its vendors cannot be held liable for damage or injuries resulting from the use or mis- use of cleaning products.

3.Frames:

•Wipe with a light solution of mild soap and warm water. Rinse and dry thoroughly.

Important: Do not use abrasive cleaners because they may scratch the equipment. Strong cleansers and abrasives will damage decals. Use caution around decals. Do not use solvents such as lacquer thinner, kerosene, gasoline, or similar liquids.

4.Stainless Steel Covers:

•Wipe with a light solution of mild soap and warm water. Rinse and dry thoroughly.

•If desired, or to remove corrosion, use available commercial stainless steel polishing com- pounds. Follow manufacturers’ instructions.

WEEKLY

1.Hardware:

•Check all nuts and bolts. Tighten them as required.

2.Grips:

•Check and replace as needed.

6