Loadingi Rollll Paper

1Slide the black paper stop off the end of the spindle.

Note: To use paper with a 3-inch core, attach the gray adapters to the paper stops at each end. See your Printer Guide for details.

2Position the roll as shown, then slide the spindle into the roll.

3Slide the black paper stop back onto the spindle and insert it firmly into the end of the roll.

4To adjust the tension, slide the switch to H for high tension (for most fine art papers) or N for normal.

5Open the roll paper cover.

6Place the roll paper in the printer as shown. (The black end of the spindle goes on the left.)

7Align the roll with the rails on both sides, and roll it onto the mounting brackets.

8Make sure the printer is turned on, then press the

Paper Source button until the or icon appears.

9Release the paper lever. If the lever is locked, press and hold the button for 3 seconds to unlock it.

10Feed the paper into the slot and pull it all the way through.

11Turn the roll back to remove any slack. Then align the bottom edge with the horizontal and vertical lines.

12Return the paper lever to the locked position. Then close the roll paper cover.

13Press the Pause button. The paper feeds into printing position.

14Check the printer’s control panel and select the correct media type.

2