Loadingi and Usingi Cut Sheet Paper
1Remove any roll paper from the paper path. Make sure the printer is on and the roll paper cover is closed.
2Press the 
Paper Source button until the 
icon appears on the LCD.
3Release the paper lever. If the lever is locked, press and hold the 
button for 3 seconds to unlock it.
Note: If you’re printing on small sheets or fine art paper, do not release the paper lever.
4Feed the sheet into the paper slot until it meets resistance. Make sure the right and bottom edges of the paper are straight and aligned with the horizontal and vertical lines on the printer.
5If you released the paper lever, return it to the locked position.
6Press the 
Pause button. The sheet feeds into the printing position automatically.
Caution: To avoid damaging the printer, never move the paper lever during printing, or while the Power or Pause light is flashing.
7Print your page. After it is finished, the sheet stays in the printer.
8To remove your print, press the
button.
Printing on Posterboard
When you print on posterboard or other thick media (more than 19 mil thick), you should open the front cover before loading as described below.
1Make sure the printer is on and the roll paper cover is closed.
2Press the 
Paper Source button until the 
icon appears on the LCD.
3Release the paper lever. If the lever is locked, press and hold the 
button for 3 seconds to unlock it.
4Open the front cover. (The cover has a lip that acts as a paper support when the cover is open.)
5Feed the posterboard into the paper slot until it meets resistance.
6Align the board with the scale on the roll paper cover.
7Return the paper lever to the locked position. Then close the front cover.
8Press the 
Pause button. The board feeds into the printing position automatically.
9Run your print job. After it is finished, the posterboard stays in the printer.
10To remove the print, hold it and release the paper lever.
4