Loading non-standard sized film

Follow these steps to load non-standard sized film:

 

1. Place the film directly on the

Calibration area

document table making sure the

 

glossy (smooth) side of the film

 

faces down.

 

If the reflective document mat is installed in the transparency unit, remove it.

2.Close the TPU and begin your scan.

If you’re using EPSON Scan, set the focus position to 0.0.

An area 2±1.5 mm from the horizontal and vertical edges of the document table glass will not be scanned.

The scanner will generate an error message if the calibration area is blocked. Also, dirt or dust on the calibration area can result in vertical lines being added to the image. Keep the calibration area clear and clean.