4.Hold down the ID button on the remote control while you press the numeric button that matches the projector's ID. Then release the buttons.

5.Press the ID button on the remote control to check if the ID-setting process worked. You see a message displayed by the projector.

•If the remote control is listed as On, the remote control ID is set to operate only the listed projector.

•If the remote control is listed as Off, the remote control ID is not set properly. Repeat the steps above to set the ID to match the projector you want to control.

Note: You must set the remote control ID to match the projector ID each time you turn on the projector you have set it to control.

6.To allow the remote control to operate any compatible projectors again (ID number is zero), repeat the steps above and set the remote control ID number to 0.

Parent topic: Projector Identification System for Multiple Projector Control

Matching Multiple-Projector Display Quality

You can match the display quality of multiple projectors that will project next to each other.

1.Turn on all the projectors on which you want to match the display quality.

2.Set ID numbers on each projector.

3.Make sure all the projectors are using the same Color Mode setting.

4.It is best to match two projectors at a time, so set the remote control ID to match the first projector.

103