•Except as specifically explained in this manual, do not attempt to service this product yourself. Refer all servicing to qualified personnel. Opening or removing covers may expose you to dangerous voltages and other hazards.

•Never open any covers on the projector except as specifically explained in this manual. Never attempt to disassemble or modify the projector. Refer all repairs to qualified service personnel.

•Unplug the projector from the wall outlet and refer servicing to qualified service personnel under the following conditions: If it does not operate normally when you follow the operating instructions, or exhibits a distinct change in performance; If smoke, strange odors, or strange noises come from the projector; If the power cord or plug is damaged or frayed; If liquid or foreign objects get inside the projector, or if it has been exposed to rain or water; If it has been dropped or the housing has been damaged.

•Do not touch the plug during an electrical storm. Otherwise, you may receive an electric shock.

•Unplug the projector when it will not be used for extended periods.

•Do not use the projector where it may be exposed to rain, water, or excessive humidity.

•Do not use the projector where it may be exposed to excessive dust or smoke.

•Do not use or store the projector or remote control in a hot location, such as near a heater, in direct sunlight, or in a closed vehicle.

•If you use the projector in a country other than where you purchased it, use the correct power cord for that country.

•Do not stand on the projector or place heavy objects on it.

•Do not use the projector outside of the required temperature range of 41 to 95 ºF (5 to 35 ºC). Doing so may cause an unstable display and could lead to projector damage.

•Do not store the projector outside of the required temperature range of 14 to 140 ºF (-10 to 60 ºC) or in direct sunlight for long periods of time. Doing so may cause damage to the case.

•Do not place anything that can become warped or damaged by heat near the exhaust vents. Do not bring your hands or face close to the vents while projection is in progress.

•Before you move the projector, make sure its power is turned off, the plug is disconnected from the outlet, and all cables are disconnected.

•Never try to remove the lamp immediately after use because it will be extremely hot. Before removing the lamp, turn off the power and wait at least an hour to allow the lamp to cool completely.

•Do not place the source of an open flame, such as a lit candle, on or near the projector.

•Do not modify the power cord. Do not place heavy objects on top of the power cord or bend, twist, or pull it excessively. Keep the power cord away from hot electrical appliances.

163