The warning light is flashing orange.

High-speed cooling is in progress. If the projector gets too hot again, projection stops automatically. Make sure there is plenty of space around and under the projector for ventilation. Clean or replace the air filter if necessary (see page 51).

The warning light is red.

The projector is too hot, which turns off the lamp automatically. Let it cool for five minutes, then turn it back on. Make sure there is plenty of space around and under the projector for ventilation. Also, clean or replace the filter if necessary (see page 51).

The warning light is flashing red at one-second intervals.

■The lamp cover may be loose or off. Make sure it’s securely fastened (see page 52).

■There is an internal problem. Turn off the projector and, when the P power light stops flashing, unplug it. Contact your dealer.

The warning light is flashing red at half-second intervals.

The lamp needs to be replaced (see page 52).

Checking the Projector Status

You can use the Info menu to view information about the current display settings and how long the projection lamp has been in use. To access the Info menu:

1.Press the Menu button on the projector or remote control.

2.Use the menu navigation buttons to open the Info menu. The following information appears:

■

Lamp Hours

■

Video Signal

■

Source

■

Refresh Rate

■

Input Signal

■

Sync Info

■Resolution

Note: The information displayed depends on the currently selected image source. The Lamp Hours shows 0H until you’ve used the lamp for at least 10 hours.

56