Maintenance 59

Resetting the Lamp Usage Timer

After replacing the lamp, plug the projector back in and turn on the main power switch on
the back. Press the Ppower button on the projector or the
On
button on the remote control.
Then follow these steps to reset the lamp usage timer:
1. Press the
Menu
button on the projector or remote control.
2. Use the menu navigation buttons to open the
Reset
menu, then select
Reset Lamp
Hours
.
3. When you see a confirmation prompt, highlight
Yes
and press the
Enter
button.
4. When you’re finished, press the
Menu
button to exit.
The lamp usage timer shows 0H until you’ve used the lamp for at least 10 hours.
Checking the Projector Status
You can use the Info menu to view information about the current display settings and how
long the projection lamp has been in use. To access the Info menu:
1. Press the
Menu
button on the projector or remote control.
2. Use the menu navigation buttons to open the
Info
menu. The following information
appears:
Note: The information displayed depends on the currently selected image source. The Lamp
Hours shows 0H until you’ve used the lamp for at least 10 hours.
The resolution indicates the total number of scan lines in the source signal. The number of visible
scan lines depends on the signal format standard and selected display settings.
■
Lamp Hours
■
Sync Info
■
Source
■
Video Signal
■
Input Signal
■
Deep Color (color depth)
■
Resolution
■
Status (error information)
■
Scan Mode
■
Serial Number
■
Refresh Rate