42 Making Detailed Adjustments
3. Do one of the following:
■
Select
Reset All
to return all projector settings to their original defaults (except
Component, Memory, Language, Network, and Lamp).
■
Select
Reset Memory
to clear all memory settings.
■
Select
Reset Lens Position
to clear all lens position memory settings.
■
Select
Reset Lamp Hours
to clear the lamp usage timer and reset it to zero.
You should reset the lamp timer only when you install a new projector lamp. See
page 59 for more information.
Customizing Projector Features
Use the settings in this section to adjust the image size and position, suppress on-screen text,
and select basic setup options.

Image Sizing

Before adjusting any of these settings, make sure you have already selected an appropriate
aspect ratio for the type of picture you’re viewing (see page 26).
■Overscan
For component video formats, this setting lets you see the edges of the image that are not
normally visible in the picture. If you see interference when you set
Overscan
to
Off
, try
adjusting the
Position
as described below.
■Position
Note: This setting cannot be used with a signal input through the HDMI 1 or HMDI 2 port.
Use the arrow buttons to fine-tune the position of the image on the screen.
■
Aspect
This setting lets you change the aspect ratio of your image, and works the same as
pressing the
Aspect
button on the remote control. See page 26 for more information.
Signal> Advanced > Overscan
Signal> Position
Signal> Aspect