Making Detailed Adjustments 47
■Wired LAN
Assigns a network address to your projector. Select
DHCP
and set it to
On
if your
network assigns addresses automatically. Otherwise, select
Off
and enter the projector’s IP
address, subnet mask, and gateway address.
Note: You can enter a number from 0 to 255 in each field of the address. For the IP Address
and Gateway Address, you cannot use 0.x.x.x, 127.x.x.x, or 224.0.0.0 through
255.255.255.255. For the Subnet Mask, do not use 0.x.x.x through 254.x.x.x, or
255.255.255.255.
■Mail
Turn on
Mail Notification
if you want to receive e-mail alerts about the status of the
projector (see page 51).
Select
SMTP Server
to enter the IP address for your SMTP server.
Note: You can enter a number from 0 to 255 in each field of the address. You cannot use
0.x.x.x, 127.x.x.x, or 224.0.0.0 through 255.255.255.255.
Select
Port Number
to enter the port number for the SMTP server. The default value is
25. You can enter a number from 1 to 65535.
Select an
Address Setting
to enter up to three e-mail address where you want to be
notified if a problem occurs. You can also select the types of problems about which you
want to be notified.
■AMX Device Discovery
When the projector is connected to a network, select
On
to allow the projector to be
detected by AMX Device Discovery. Select
Off
if your network doesn’t use an AMX
controller.
Network> Wired LAN
Network> Mail
Network> AMX Device Discovery