Principles of the Printing Operation

Operating Principles

Stylus Color Service Manual

Principles of the Printing Operation

The printhead operates in one of two modes to inject ink from each nozzle:

■ Normal state

No electrical charge is applied to the MLP (Multi-Layer Piezoelectric) element attached to the

back of the cavity, and pressure inside the cavity is kept at a constant level.

■ Injecting state

The head data signal is applied to the specific nozzle control line to select the active nozzle for

printing, and the MLP element is gradually charged by the drive voltage. By charging the MLP

element, the vibration plate is bent to compress the cavity. Then, ink is injected from the

nozzle.

Nozzle

Normal

state

Nozzl

Injectir Ig

state

@

Figure 2-3. Principles of the Printing Operation

When the ink charge or printhead cleaning operation is performed, the ink in the cavity is

vacuumed out with the pump mechanism. During printing, on the other hand, the ink is

simultaneously supplied from the ink cartridge and injected from the nozzle, according to the

change of volume in the cavity.

A thermistor is attached to the side of the color printhead drive board to monitor the temperature

because the viscosity of the ink varies, depending on the temperature. The detected temperature

level is fed back to the printhead drive voltage control circuit to change the time of the Tc pulse.

(The Tc pulse is shown in Section 2.3.2.5.)

Rev. A

2-3

Page 33
Image 33
Open full-size image