Epson PowerLite 745c Projector
6. Press Menu to close the Password Protect menu.
Starting the Projector with a Password
Caution:
If you lose the remote control, you will not be able to enter the password; so keep the remote control in a safe place at all times.
When the password function is enabled, you see this screen when you turn on the projector:
Hold down the Num button on the remote control as you use the numeric keypad buttons to enter the password. Once you have entered the password correctly, the password screen closes, and projection begins.
Disabling the Projector’s Buttons
When you enable the Operation Lock function, all the projector’s buttons are disabled except the P Power button. This is useful, for example, if you want to prevent students in a classroom from playing with the projector.
1.Press the Menu button.
2.Select the Setting menu and press Enter.
3.Select Operation Lock and press Enter.
4.Select ON and press Enter. Then select Yes and press Enter to confirm the setting.
5.Press the Menu button to exit the menu system.
Note:
You can cancel Operation Lock by pressing the projector’s Enter button for 7 seconds.
Presenting Over a Wireless Network
If the password is not correct, you see the message Wrong password. Please try again. If you enter an incorrect password three times in succession, you see the message The
projector’s operation will be locked. Request code xxxxx
and the projector switches to standby mode for approximately 5 minutes. Write down the request code. Then disconnect the projector’s power cord from the electrical outlet, reconnect it, and turn the projector back on. When you see the Password Protect Release screen, enter the correct password.
If you have forgotten the password, contact Epson for assistance and give them the request code number that appears in the Password Protect Release screen.
If you enter an incorrect password 30 times in a row, the projector remains locked and you must contact an authorized Epson servicer to unlock it.
Using EMP NS Connection, you can project images shown on your computer screen directly to your audience without connecting the projector to your computer. Before you begin, make sure you’ve installed EMP NS Connection from the
Starting EasyMP™
Before you can connect to the projector wirelessly, you have to switch it to EasyMP mode.
1.Turn on the remote control and the projector. Press the EasyMP button on the remote control to select EasyMP as the source.
2.Locate the Epson 802.11G/B card that came with your projector. Insert it with the label facing upward.
Note:
Only the Epson 802.11G/B card is guaranteed to work. Other cards may not be compatible.
10 - Epson PowerLite 745c Projector | 8/04 |