Epson PowerLite 745c Projector
3.Click Use IP connect mode, then click OK. You see this screen:
4. Click IP connection. You see this screen:
5.Enter the projector’s IP address and click Search.
The IP address appears in the Projector list and a
searching icon displays.
Indicates search in progress
If the search fails to find a projector with the specified IP address, the searching icon turns into a question mark. If this happens, run EasyMP to check the projector’s IP address, then repeat this step.
Note:
If you still don’t see the projector, make sure the Internet Connection Firewall is disabled.
6.Click the projector you want to connect to, then click the Connect button. If more than one projector is listed, you can select additional projectors and connect to them at the same time.
7.If you are prompted for a keyword, enter the
Follow these steps to remove the card from your projector.
1.If you’re running NS Connection, click Disconnect on the control bar.
Click here
2.Check the card access light to make sure it isn’t flashing.
Caution:
Never remove the card while the card access light is green or flashing. You may damage the card or lose data.
3.Press the eject button. The button pops out.
Eject button
Access light
4.Press the eject button again. The wireless card partially ejects.
5.Pull the card straight out. Then press the eject button back in to prevent it from being damaged.
8/04 | Epson PowerLite 745c Projector - 17 |