Epson PowerLite 745c Projector

Depending on whether your projector is set up to

You see one of these screens:

connect in Ad Hoc mode or Access Point mode (also called

 

infrastructure mode), you see this screen:

 

3.If you’ve already configured the projector for your wireless network, go to “Projecting Wirelessly” on page 15. Otherwise, continue with the next section.

Configuring the Connection

You must configure both the projector and your computer’s network settings to project wirelessly.

You can configure the projector for either of the following modes:

Ad Hoc mode: Lets you connect just one computer at a time; you need a computer with a wireless (802.11g or 802.11b) network card or adapter, or a Macintosh with an AirPort® or AirPort Extreme card.

Access Point mode: Lets multiple computers access the projector, or trade off control of the projector; you need a wireless (802.11g or 802.11b) access point or an AirPort (or AirPort Extreme) base station, and one or more computers with wireless network cards or adapters.

1.Switch the projector to EasyMP mode and insert the Epson 802.11G/B card.

2.When you see the EasyMP screen, press the Enter button on the remote control to select Config.

3.Use the pointer button to highlight Basic under

Wireless LAN, the press Enter.

4.Select either Easy connect mode (for Ad Hoc) or Access point mode.

Ad Hoc mode

Access

Point mode

5.Make sure the projector has a unique name so you can identify it when connecting to it from your computer.

Use the pointer button on the remote control to highlight the Projector Name text box, then press Enter. The text box turns yellow to indicate you’re in input mode.

Press the pointer button up to select individual letters in alphabetical order, or down to select letters in reverse

order. Then press the pointer button to the right to move to the next character position. When done entering a new setting, press Enter.

To enter numbers, press and hold the Num button on the remote control while pressing number buttons on the numeric keypad. (The button lights up to indicate that the numeric keypad is active.) Press the Num button again to exit numeric keypad mode. When done entering the setting, press Enter.

8/04

Epson PowerLite 745c Projector - 11