Epson 750 1.4.6 Errors

EPSON Stylus Photo 750 Revision A
Product Description Function 23
Table 1-19. Printer Status displayed on the control panel
NOTE:*1 Refer to “Fatal Error” under the “Errors” on page -23.
*2 EEPROM reset does not mean to erase all address in
EEPROM. (See “Special Setting Mode” on page -22)
*3 -- in the table above means no change.
1.4.6 Errors
In this printer, when the following conditions are detected. the printer
goes to the error condition, sets ERROR signal Low and BUSY signal
High and stops receiving the data. The printer becomes unable to print
at this time. However, if the printer communicated by IEEE1284.4
protocol, the printer does not become unprintable state.
†Ink Out
When the printer runs out most of the ink of any one color, it
indicates ink-low warning and keeps printing. When the print runs
out the whole ink of any one color, it indicates ink-error and stops
printing. Exchanging ink cartridges is required on this state. An ink
cartridge taken out once should not be used again. Re-installation of
the cartridge upsets the ink level detection and may cause a serious
problem to the print head as a result.
†Paper out
When the printer fails to load a sheet, it becomes “paper out error”
condition.
†Paper Jam
When the printer fails to eject a sheet, it becomes “paper jam error”
condition.
Printer Status
Indicators
Power Ink Out
(Black) Ink Out (Color) Paper Out Priority
Power on condition On -- -- -- 9
Ink sequence Blink -- -- -- 6
Ink cartridge
exchange mode Blink------5
Data processing Blink -- -- -- 8
Paper out*1 -- -- -- O n 4
Paper jam*1 -- Off Off Blink 3
No ink cartridge or
Ink out (black) -- On -- -- 7
Ink level low (black) -- Blink -- -- 7
No ink cartridge or
Ink out (color) -- -- O n -- 7
Ink level low (color) -- -- Blink -- 7
EEPROM and
Timer IC reset*2 --
On
(for 1
second)
On
(for 1
second)
On
(for 1
second)
--
Maintenance
Request Blink Blink Blink Blink 2
Fatal Error*1 Blink On On Blink 1
CAUTION
Never use or re-install the cartridge, which is taken
out once. Re-installation of the used cartridge
disturbs the normal ink out detection.