EPSON Stylus Photo 750 Revision A

Disassembly and Assembly Disassembly 64

4.2.5.4 Motor Assembly PF Removal
1. Remove the upper housing.(See “Housing Removal” on page -54)
2. Remove “Absorber Tray, Assembly;A”. (See “Absorber Tray,
Assembly;A Removal” on page -58)
3. Remove the following gears which are located at the left side of the
printer mechanism.
Gear, 67.2
Combination gear, 8.8,21.6
Combination gear, 8,14.4
Gear, 36
Figure 4-14. Motor, Assembly, PF Removal
4. Remove the hexagon nut and ”Motor, Assembly, PF”.
Figure 4-15. Motor, Assembly, PF Installation
M o to r , A s s e m b ly , P F
Hexagonal Nut
Com pression S pring, 0.9
Gear, 67.2
Lock Ring
Gear, 36
Com bination Gear, 8.8, 21.6
Com bination Gear, 8, 14.4
CHECK
POINT
When removing the “Motor, Assembly, PF”, first,
slightly pull out the “Motor, Assembly, PF” from the
frame and slide the motor shaft to a larger cut out of
the frame and remove it.
Be careful for the routing direction of the cable from
the “Motor, Assembly, PF”.
Motor, Assembly, PF
(behind the fram e)
Cable Direction
Put the m otor shaft once in a larger hold
then slide it to a sm aller hole