Configuring the Print Server

After the software is installed, you’re ready to establish a connection to the print server and configure it for your wireless network.

Click START

1.When you see the Wireless Server Search window, click START.

Wait until you see server information like the following (you should not have to wait more than 60 seconds):

This information

 

 

 

This number

appears when the

 

 

 

indicates the

 

 

 

server is found

 

 

 

signal strength

If WP-Admin fails to pick up a signal from the print server, try holding down the print server’s test button for five seconds to reset it. The lights go out, then both the green and yellow lights come on briefly. The yellow light remains on when your network has a connection to the print server.

If it still fails to pick up a signal, check the solutions beginning on page 40.

2.If WP-Admin picks up a signal from more than one print server, select the connection that matches the MAC address on the back of your print server.

3.Check the signal strength to make sure you have a good link to the print server. If you have a link, click STOP. Then click CONFIGURE.

You see a password window.

34