![](/images/new-backgrounds/1145314/14531481x1.webp)
SCREEN Menu
SCREEN Menu (continued)
Item
Description
| Using the ▲/▼ buttons turns on/off the message function. | |
| TURN ON ó TURN OFF | |
| When the TURN ON is selected, the following message function works. | |
| “AUTO IN PROGRESS” while automatically adjusting | |
| “NO INPUT IS DETECTED” | |
| “SYNC IS OUT OF RANGE” | |
| “Searching…” while searching for the input | |
MESSAGE | “Detecting…” while an input signal is detected | |
| The indication of the input signal displayed by changing | |
| The indication of the aspect ratio displayed by changing | |
| The indication of the PICTURE MODE displayed by changing | |
| The indication of the MY MEMORY displayed by changing | |
| The indication of “FREEZE” and “II” while the projector is in the FREEZE mode. | |
| • If the projector goes into the FREEZE mode while the TURN OFF | |
| is selected, the picture on screen is frozen without any messages, | |
| which is not a malfunction (23). | |
| Each input port for this projector can have a name applied to it. | |
| (1) Use the ▲/▼ buttons on the SCREEN Menu to | |
| select SOURCE NAME and press the ► button. | |
| The SOURCE NAME menu will be displayed. | |
| (2) Use the ▲/▼ buttons on the SOURCE | |
| NAME menu to select the port to be named | |
| and press the ► button. Right side of the | |
| menu is blank until a name is specified. | |
| The SOURCE NAME dialog will be displayed. | |
| (3) The current name will be displayed on the | |
| first line. Use the ▲/▼/◄/► buttons and the | |
| ENTER or INPUT button to select and enter | |
| characters. The RESET button can be used | |
SOURCE NAME | to erase 1 character at a time. Also if you | |
move the cursor to DELETE or ALL CLEAR on | ||
| ||
| screen and push the ENTER or INPUT button, | |
| 1 character or all characters will be erased. The | |
| name can be a maximum of 16 characters. | |
| (4) To change an already inserted character, | |
| press the (▲) button to move the cursor to the | |
| first line, and use the ◄/► buttons to move | |
| the cursor on the character to be changed. | |
| After pressing the ENTER or INPUT button, the character is selected. | |
| Then, follow the same procedure as described at the item (3) above. | |
| (5) To finish entering text, move the cursor to the SAVE on screen | |
| and press the ENTER or INPUT button. To revert to the previous | |
| name without saving changes, move the cursor to the CANCEL on | |
| screen and press the ENTER or INPUT button. |
41