EPSON FX-980

Using the Front Push Tractor

To use the front push tractor, load continuous paper in the front slot. For more information on when to use the front push tractor, see “Available Paper Paths” on page 7.

Note:

The tractors are installed in the front push and rear push positions when the printer is shipped. The rear tractor cannot be removed.

Installing the tractor in the front push position

If a tractor is installed in the front push position, skip to the next section, “Loading paper onto the front push tractor.”

If a tractor is installed in the pull position, you need to remove it and install the paper tension unit. To install the tractor in the front push position, follow these steps:

1.Make sure the printer is turned off. Open the front paper guide by ()pulling the tab at the center of the guide. Then remove the guide by grasping both sides () and pulling it straight out of the printer.

tab

2.Insert the tractor into the mounting slots () and press down both ends of the tractor () to make sure that it is firmly seated.

You are now ready to load continuous paper onto the front push tractor as described in the next section.

Loading paper onto the front push tractor

To load paper onto the front push tractor, follow these steps:

1.Make sure the printer is turned off. Open the front paper guide by pulling the tab at the center of the guide. Then remove the guide by grasping both sides and pulling it straight out of the printer. Check that the tractor is installed in the front push position.

tab

2.Set the paper release lever to the front push tractor position. Then set the paper thickness lever to accommodate your paper thickness.

front push tractor position

3.Release the left and right sprockets by pushing the sprocket lock levers backward.

12 - EPSON FX-980

4/99