EPSON
4.Slide the left sprocket to the left margin of your paper using the arrow mark inside the printer. (Printing starts at the arrow mark.) Then pull the lever forward to lock it in place.
See “Paper Alignment” on page 4 and “Printable Area” on page 5 for more information on the left margin position.
5.Slide the right sprocket to match the width of your paper, but do not lock it. Move the paper support midway between the two sprockets.
6.Open both sprocket covers. Make sure your paper has a clean, straight edge and fit the first three holes of the
7.Slide the right sprocket to remove any slack in the paper, then lock it in place by pushing the sprocket lock down.
8.Attach the front paper guide by sliding it along the mounting slots. Then close the front paper guide.
9.Slide the edge guides to the middle of the top paper guide base. Lift the center section of the paper guide base up and lay it flat. Make sure that the printer cover and the paper guide cover are closed.
edge guides
Always close the printer cover before printing. The printer does not print when the cover is open.
10.Turn on the printer. You may need to check andchange the printer driver settings. When the printer receives data, it automatically loads the paper and starts printing. The printed pages are fed over the paper guide toward the back of the printer.
After you finish printing, follow the steps in the next section to tear off your printed document. If the first line on your page appears too high or low, you can fix this using the micro adjust feature. See “Adjusting the
Never use the knob to adjust the
4/99 | EPSON |