Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the above picture shown, please use refill kits to fill ink into Reservoir bottles. Carefully pull out the rubber plugs from the refill holes.(there is possibility of ink spattering. Be careful!) Refill ink according to the color in short supply. Then put the rubber back. (Please keep the printer and the reservoir at the same horizontal line during the process of refilling ink.)
6、Attention for maintenance:
Take out the CISS including the inner cartridges and other components. Then remove support arm from printer, and place the original cartridges in. Please inquire local dealer before sending to maintenance.
7.Notice:
1.Please don’t take out cartridge at random after installing the CIS system. Keep the reservoir bottles on the same level with the printer.
2.Try to keep at least 1/2 inch of ink in the bottles, as you don’t want to run out of ink and draw air into the cartridge.
3.Don’t place the Reservoir Bottles higher or lower much than the printer.
4.To be used in a dry place between 15 and 35 degree. Avoid exposure to direct sunlight.
5.Don’t put the continuous ink supply systems reversed or leaning during the shipment. Please make sure all the ink filling holes and Ventilation holes are closed tightly during the transportation. Otherwise, the ink shall leak out.
6.Don’t sway the cartridge frequently. It may cause ink leakage.
7.Don’t pull out the connector of cartridge and don’t tear off adhesive tape at the bottom of cartridge.
8.Warning:
1.Not drinkable; keep it out reach of children.
2.Avoid exposure to direct sunshine and don’t keep it in high or freezing temperature.
3.Avoid collision and fallen down.
