Epson C8230, C82305 Jumpers, Figure 2. Jumpers

Note

• The printer will assume a setting of 1,200 BPS for switch combinations other than those shown above.

•Since the maximum transmission speed (baud rate) depends on your type of printer, refer to your printer’s manual for details.

Jumpers

The jumper is a small terminal used for connecting or disconnecting a circuit. The jumper is on when the jumper plug covers both wires of the terminal. Jumper settings can be changed by either attaching or removing the rectangular jumper plug. If the jumper is to be turned off, connect it to just one of the two terminal pins as shown in the figure below. By doing this, you can avoid losing the unused jumper plug.

Figure 2. Jumpers

10