DIP switch and jumper settings

Before you install the C82305 * /C82306 * interface, you may need to adjust the DIP switch 2 and jumper settings. You can change the DIP switch 1 settings after you install the interface. When making DIP switch setting changes, it is best to use a pointed device, such as a ball-point pen or small screwdriver.

Caution

All changes of DIP switch and jumper settings should be made with the printer power turned off. New settings become valid only when the printer is turned on.

DIP switches

The settings on DIP switches allow you to change interface functions. The two sets of DIP switches on the C82305 * /C82306* are labelled SW1 and SW2. Each set contains a number of individual toggle-type switches that can be set either on or off. The individual switches are referred to by set (SW1 or SW2) and number. Therefore, the switch in set SW1 marked by the small number 3 is called DIP switchl-3.

5