Letter Quality 5219 emulation

Jumper

Connected

Disconnected

 

 

 

J5

Selects 5219 ESWP letter

lnvalid selection

 

quality emulation

 

 

 

 

J6**

Sends Epson EWP 9-pin

Sends Epson ESC/P 24/48 -pin LQ com-

 

PX commands to the printer

mands to the printer

 

 

 

** If the interface’s self test prints a name for your printer, you do not need to set the J6 jumper.

Letter Quality 3812/HP Laser printer emulation

Jumper

Connected

Disconnected

 

 

 

 

 

 

J5

Invalid selection

Emulates an IBM 3612 printer using HP

 

 

LaserJet II commands

 

 

 

J6*

Sets the page orientation au-

Sets a fixed page orientation when you

 

tomatically when you use the

use the Computer Output Reduction fea-

 

Computer Output Reduction

ture

 

feature

 

 

 

 

*When you choose fixed page orientation, the orientation is selected by the settings of switches 6 and 7.

INSTALLING THE INTERFACE CARD

After making any necessary changes in the jumper settings, you should install the C82315* Twinax Interface Card in your printer.

Instructions on installing this interface card are included in your printer’s user’s guide. Follow these steps carefully.

SETTING THE SWITCHES

The C82315* Twinax Interface Card comes with eight switches that are used to determine many of the default settings of the interface card. Details on these settings are listed in the following section.

You can set the switches located on the rear side of the card at any time. However, the interface only checks these settings when the printer is first turned on. Always turn the printer off and then back on again after changing a setting.

5