Epson C82315 PERFORMING A SELF TEST, CONNECTING TO THE HOST COMPUTER SYSTEM, HP Lase Jet II mode

HP Lase Jet II mode

Switch	Off	On
6	Sets orientation automatically	Sets orientation to landscape
	during Computer Output	during Computer Output
	Reduction	Reduction
7	Sets orientation automatically	Sets orientation to Portrait
	during Computer Output	during Computer Output
	Reduction	Reduction
Switch	Off	On
8	Selects the C823W interface	Selects the printer’s built-in
	card	interface

PERFORMING A SELF TEST

To verify the interface is installed and the settings are correct, perform an interface self test according to the following steps.

1. Turn on the printer and load paper. Make sure the cable address (set with switches 1, 2, and 3) is not set to 7.

2.Press the TEST button on the interface. The printer then prints out a list of the jumper, switch, and feature settings, similar to the self test sample printout shown in Appendix A-l.

The name of the printer printed in the self test may differ from your printer’s actual model name.

3. Turn the printer off to end the self test.

If the warning message is printed, it indicates the interface’s emulation mode differs from the emulation mode selected by your printer.

CONNECTING TO THE HOST COMPUTER SYSTEM

After you confirm the interface is installed and settings are correct, you can connect it to the host system according to the following steps.

8