5.Make sure the name of the hard disk on you would like to install the programs is shown below the message “on the hard disk named” (where HD-SCSI 0 appears in the example).

If the hard disk name is correct, go to step 7.

6.Click Switch Disk. Then one of other hard disk names is displayed. Click again until you see the desired hard disk name.

7.Click Install to perform the easy installation. The installer starts copying the necessary files automatically.

8.Change the disk from Printing Tools (Disk1 ) to Screen Fonts (Disk2) when the installer instructs you to do so. Installer continues copying files automatically after you insert the next disk.

Note:

You need to exchange the disks several times, as the messages indicate.

9.Make sure the following message shows on your display.

Installation on the active startup disk “HD-SCSI 0” was successful. You must now restart your Macintosh to use your new software.

10.Click Restart. You are now finished copying files from the disk 3.

1-4 Installing the Programs