Paper Feeding Problems

■If paper doesn’t feed, remove it from the sheet feeder. Fan the paper, load it against the right side, behind the feeder guard, and slide the left edge guide against the paper (but not too tightly).

■If paper jams, follow these steps:

1.Press the P On button to turn off the CX6600.

2.Lift up the scanner and remove any paper that’s inside, including any small pieces that may have torn off.

Caution:

Clear paper jams by pulling the paper out towards the front of the CX6600. Never pull the paper out in the direction of the sheet feeder.

3.Turn the CX6600 back on and reload the paper. Make sure the edges are not creased or folded.

Copy Quality Problems

If you have any problems with the quality of your copies, try these solutions:

■Make sure the document is placed flat against the document table glass. If only part of the image is blurred, your document may be wrinkled or warped.

■Make sure the CX6600 is not tilted or placed on an uneven surface.

■Clean the print head; see page 31 for instructions.

■If a dotted line appears in the image, clean the scanner glass with a soft, dry, lint-free cloth (paper towels are not recommended). If the glass is still not clean, use a small amount of glass cleaner on a soft cloth. Make sure you wipe off any remaining liquid. Don’t spray glass cleaner directly on the glass.

■Make sure your paper isn’t damp, curled, or loaded face down (the printable side should be face up). Load new paper face up. Use Epson papers for proper saturation and absorption of genuine Epson inks.

■Use a support sheet with special paper or load your paper one sheet at a time.

■If you notice jagged vertical lines, you may need to align the print head. See your on-screen CX6600 Reference Guide for instructions.

■The ink cartridges may be old or low on ink; see page 33 for instructions on replacing an ink cartridge.

38Solving Problems