3.Position the left sprocket so the pins are to the left of the arrow mark on the scale. Push up the sprocket lock lever to lock it in place.
arrow mark
6.Open both sprocket covers.
sprocket cover
4.Slide the right sprocket to match the width of your paper. (Do not lock it in place yet.)
5.Center the two paper supports between the two sprockets.
paper supports
Note:
For paper less than four inches wide, remove the paper supports by pulling them off the tractor.
7.Be sure your paper has a clean, straight edge and that the printable side of the paper is facing up. Fit the first few holes over the sprocket pins and close the sprocket covers.
8.Slide the right sprocket until the paper is straight and there is no slack. Lock the sprocket by pushing up the sprocket lock lever. (The right sprocket may move slightly.)
sprocket lock lever
Note:
Be careful not to pull the paper too tightly.
10 Loading Paper On the Front Tractor