English

Press the Bump Sensor RESET Button (F) to clear the flashing LED light and reset the Bump Sensor circuit. The laser diodes will stop flashing and the rotary head will begin spinning again. The Bump Sensor ON LED Light will remain lit and the tool will remain in this operating mode.

To return the circuit to setting 1, press the Bump Sensor SET Button

(C)once again. The ON LED Light (D) will shut off indicating that the laser is in operating mode 1.

Two-Position Pivoting Head

 

This tool has been designed with a

 

Two-Position Pivoting Head for quick and

 

easy adjustments on the job. The Two-

 

Position Pivoting Head can be used to

A

position the laser for both horizontal (level)

 

and vertical (plumb) applications and to

 

adjust the laser for use with the built in Wall

 

Mount. The Two-Position Pivoting Head is

 

designed to lock the laser level into two predetermined positions (level

& plumb) through the use of a spring-loaded detent pin. To make

adjustments to the position of the laser head follow these instructions.

1.

Locate the Two-Position Pivoting Head Adjustment Lever (A) on

 

the side of the laser level, next to the “DANGER” warning label.

2.

To pivot the laser head lift the Adjustment Lever approximately

 

one quarter of the way open, enough to disengage the spring-

5.Follow the instructions for leveling or plumbing the laser. For posi- tioning the tool for use on a wall see the Wall Mount section.

6.To return the laser head to its original position repeat steps 2-4.

Wall, Floor & Tripod Mounts

The DW073 Cordless Rotary Laser has been designed with the most common accessories built directly into the base of the tool. These accessories allow the laser to be mounted onto tripods, positioned directly on the floor, and attached to walls for drop ceiling installation or other leveling jobs.

MOUNTING ON A TRIPOD

 

1.

Position the tripod on a smooth and

 

 

level surface. Set tripod to desired

 

 

height.

 

2.

Secure the laser to the tripod base

A

 

by screwing the threaded knob (A)

 

on the tripod into the 5/8" x 11

 

 

threaded insert on the bottom of the

 

 

laser level. NOTE: Be sure the tri-

 

pod you are working with has a 5/8" x 11 threaded screw.

3.Use the Two-Position Pivoting Head Adjustment Lever to pivot the laser head for a level or plumb setting.

4.Follow the instructions for leveling or plumbing the laser.

5.Turn the laser on; adjust rotation speed and controls as needed.

loaded detent pin holding the laser head in position. DO NOT

ATTEMPT to fully open the Adjustment Lever, you may damage

the spring-loaded detent mechanism. The Adjustment Lever has

been designed to release the Pivoting Head when opened only

one quarter of the way.

3. While lifting the Adjustment Lever approximately one quarter of

the way open with one hand, pivot the laser head with your other

hand until it travels 90º to a stop.

4. Release the Adjustment Lever and make sure that the spring-

loaded detent pin locks into place. The laser head should now be

locked into position and ready for use.

FLOOR MOUNT

The laser level can be positioned direct- ly on the floor for leveling and plumbing applications. Follow the instructions below for using the floor mount.

1.Place the laser on a relatively smooth and level surface

2.Use the Two-Position Pivoting Head Adjustment Lever (A) to pivot the laser head for a level or plumb setting.

A

B

C

10

Page 12
Image 12
Epson DW073 instruction manual Two-Position Pivoting Head, Wall, Floor & Tripod Mounts, Mounting on a Tripod, Floor Mount