Epson DW076 Laser Operation, Installing and Removing the Battery Pack, Specifications

CAUTION: Never attempt to open the battery pack for any rea- son. If the plastic housing of the battery pack breaks or cracks, return to a service center for recycling.

LASER OPERATION

•	Ensure that the battery is properly charged. If the “Power” LED
	light is flashing, the battery needs to be charged.
• To extend battery life per charge, turn the laser off when it is not
	in use.
•	To ensure the accuracy of your work, check the laser calibration
	often. See the Field Calibration Check section of this manual.
•	Before attempting to use the laser, make sure the tool is posi-
	tioned on a relatively smooth,secure surface.
•	Always mark the center of the laser line or dot. If you mark dif-
	ferent parts of the beam at different times you will introduce
	error into your measurements.
•	To increase working distance and accuracy, set up the laser in
	the middle of your working area.
•	When attaching to a tripod or wall, mount the laser securely.
•	When working indoors, a slow rotary head speed will produce
	a visibly brighter line, a faster rotary head speed will produce a
	visibly solid line.
• To increase beam visibility, wear a Laser Enhancement
	Glasses (not included) and/or use a Laser Target Card (not
	included) to help find the beam.

SPECIFICATIONS
Light Source	Semiconductor laser diode
Laser Wavelength	630 – 680nm Visible	English
Laser Power	<5mw, CLASS IIIa LASER
	PRODUCT
Rotation Speed	approx. 600 rpm
Self-Leveling Range	± 5°
Indoor Visible Range	200' (61m) diameter
Range with Detector	1500' (450m) diameter
Level Accuracy	± 1/8" per 100'
	(± 3mm per 31m)
Power Source	9.6V–18V DEWALT batteries
Operating Temperature	23°F to 122°F (-5°C to 50°C)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Water Resistant	IPX4
Usage	Indoor and Outdoor
Altitude	Up to 6560' (2000m)
Maximum Relative	95%
Humidity
Rated Pollution Degree	2

•	Extreme temperature changes can cause movement or shifting
	of building structures, metal tripods, equipment, etc., which can
	effect accuracy. Check your accuracy often while working.
•	If the laser is dropped or has suffers a sharp blow, have the
	calibration system checked by a qualified service center before
	using the laser.

NOTE: The DW076 rotary laser has no remote control capability.

Installing and Removing the Battery Pack

NOTE: Make sure your battery pack is fully charged before you install it.

INSTALLING THE BATTERY PACK

1.Rotate the battery adapter plate (A) so that the applicable cut out for 9.6, 12, 14.4 volt pack or the 18 volt pack is aligned with the battery contacts facing the inside of the cut out.

A

B

7